Built for Where You're Headed
Every strap is cut, stitched, and finished by hand in a small Wyoming workshop — built to hold up out on the water, not sit on a shelf.
Buck Brown
Burgundy
Black
Russet
Hand-cut & hand-stitched in small batches — Wyoming workshop.
Before there was a slider for everything, there was a knot. The Knotted strap is our slimmest build, finished the way straps were made before hardware did all the adjusting — a hand-tied knot set to a fixed length, instead of a slider you push up and down the cord. It's the lightest strap we make, and the most direct expression of the material: leather, a knot, and GripTite rubber ends holding it to the frame. 20" x 3/16".
Shown in Russet and Burgundy
Every strap starts with real veg-tan traditional harness leather, milled by Wickett & Craig — trusted for generations because it holds up instead of falling apart.
Each strap is hand-cut and hand-stitched in small batches, finished with powder-coated brass hardware in a black finish, and fitted with rubber ends built to grip and hold under real use. Six leather-stamp options — Brown Trout, Mountain Range, Elk & Antler, Compass Rose, Pine Tree, or none at all — let you make it yours.
All straps measure 20" long and adjust via slider for a comfortable fit (the Knotted uses a hand-tied knot in place of a slider).
Slim — 3/8" wide
Reg — 5/8" wide
Knotted — 3/16" wide
Braided Slim — 3/8" wide
Braided Reg — 5/8" wide
Not sure which width is right for you? The Slim and Braided Slim sit lower profile, while the Reg and Braided Reg give a bit more presence on the water.
Every strap is cut, stitched, and finished by hand in a small Wyoming workshop — built to hold up out on the water, not sit on a shelf.